Setting USB HID

A PC can be connected directly to the USB DEVICE connector on the back side of the balance.
For data transmission, the interface parameters of the balance must match with those of the peripheral device.

Mode "Protocol"

In mode "Protocol", the protocol defined for the application is output automatically or with the [PRINT]-key, depending on the setting.

• Mode of output as "Protocol"

• Baudrate, parity and handshake must match with the interface parameters of the connected peripheral device. In an environment with high levels of interference, it is recommend to keep the baudrate as low as possible.

• Format of the protocol output with 40 or 24 characters width

Mode "Measurement transfer"

In mode "Measurement transfer" by pressing the soft button "Transfer", the current weight value is transferred according the set format of the "Measurement transfer". Hence, the soft button {Transfer} must be activated in the “Action bar”.

• Select mode for the of output as "Measurement transfer"

Note, to ensure to activate on the “Action bar” the soft button {Transfer} in the mode "Measurement transfer".

• Baudrate, parity and handshake must match with the interface parameters of the connected peripheral device. In an environment with high levels of interference, it is recommend to keep the baudrate as low as possible.

• "Time stamp", "Device ID" and "Net/Gross/Tare" are optionally output with the measured value, whereby the gross and tare values are output on a separate lines.

• Press the soft button {Transfer} to transfer the current values.