Setting USB serial port

A PC can be connected directly to the USB DEVICE connector on the back side of the balance.
For data transmission, the interface parameters of the balance must match with those of the PC.

Data reception

A list of possible remote control commands is provided at the end of this help text.

Data sending

Mode Protocol

In mode Protocol, the protocol defined for the application is output automatically or with the [PRINT]-key, depending on the setting.

• Mode of output as Protocol

• Baudrate, parity and handshake must match with the interface parameters of the connected peripheral device.

• Format of the protocol output with 40 or 24 characters width

Mode Measurement transfer

In mode Measurement transfer by pressing the soft button Transfer or the [PRINT]-key respectively (depending on the trigger setting), the current weight value is transferred according the set format of the Measurement transfer. If trigger is set on transfer button, the soft button [Transfer] must be activated in the Action bar.

• Select mode of output as Measurement transfer

Note, to ensure to activate on the Action bar the soft button [Transfer] in the mode Measurement transfer.

• Baudrate, parity and handshake must match with the interface parameters of the connected peripheral device.

• Type of trigger which initiates the transfer.

• Time stamp, Device ID, ID and Net/Gross/Tare are optionally output with the measured value, whereby the gross and tare values are output on a separate lines.

• If trigger is set on Transfer button, press the soft button [Transfer] to transfer the current values.

• If trigger is set on Print key, press the [PRINT]-key to transfer the current values.

Remote control commands

Each remote command has to be closed with CR LF which corresponds to pushing the [Enter] key. Commands can be acknowledged using ACK1.

Command specification

ACK0       : Acknowledge sending mode Off